PREMIUM
ARTICLE

FIVE TOP HEAT PUMP CONTROL TIPS FOR INSTALLERS THIS HEAT PUMP WEEK

SPONSORED

Conversations about heat pumps tend to focus on sizing, pipework, emitters and system design. However, it is worth looking at the role controls can have on how a system performs once the installation is complete. 

To help installers navigate conversations about how best to support heat pump performance and meet homeowner comfort expectations, Resideo has expanded its recently launched Heat Pump Control Report: Practical approaches to controlling heat pumps, with additional technical guidance on heat-pump-optimised control. 

Ian Little, UK Business Development Manager, at Resideo, takes a look at the top five practical takeaways installers can consider to help deliver stable heating comfort while avoiding unnecessary system cycling:

1. Regularly monitor room temperature 

Comfort starts with accurate temperature monitoring. Rather than allowing room temperatures to drift significantly before reacting, heat-pump-specific controls can regularly compare the actual room temperature against the target setpoint. This enables the system to respond more smoothly and maintain a more consistent indoor environment.

2. Configure controls specifically for heat pumps

Heat pumps do not operate in the same way as traditional boilers, so heating control settings should reflect that difference. Installers need to configure controls for the connected heat pump, rather than relying on generic boiler control settings.

eters such as cycles per hour, minimum run times and minimum off times should be reviewed during commissioning to confirm they align with manufacturer recommendations and system design requirements.

3. Avoid unnecessary compressor cycling

Frequent starts and stops can place additional demands on a heat pump system. Appropriate minimum run and off times can help reduce unnecessary cycling and support smoother operation.

Resideo’s heat-pump-optimised control guidance indicates that minimum on time should usually be at least 20 minutes. Minimum off time should match the heat pump manufacturer’s recommendation, usually at least five minutes. Paying attention to these settings can be a simple but important step during commissioning.

4. Prioritise comfort as well as demand

As a room approaches its target temperature, the control algorithm can adjust when to call for heat while still respecting configured cycle limits and minimum on/off times. This helps create a balance between responsive comfort and controlled heat pump operation.

Importantly, maximum cycle rates should be viewed as a limit, not a target. If heating demand is low, the system should be able to operate with fewer cycles while continuing to maintain comfortable conditions.

5. Make controls easy for homeowners to use

Even the most advanced heating system needs to be straightforward for homeowners to use. Consumers increasingly expect intuitive controls that allow them to manage comfort easily and confidently.

The most effective control strategies balance the technical requirements of the heat pump with the practical expectations of the homeowner. Thermostat configuration should be considered alongside minimum flow, system volume, hydraulic design, weather compensation and the heat pump manufacturer’s control strategy. When installers get this right, they can help deliver stable operation and responsive comfort while meeting customer expectations.

As the UK’s heat pump market continues to develop, understanding control strategy is becoming an increasingly valuable skill for installers. For those looking to strengthen their knowledge during Heat Pump Week, Resideo’s updated report is supported by an InstallerSHOW discussion. Featuring Ian Little alongside Steve Warrington, UK Sales Director, it explores heat pump controls, zoning and lessons from more established European markets. Together, these resources provide practical guidance to help installers build confidence in heat pump system optimisation.

Watch the full discussion here, and to view the new technical points download the full report.

Don’t miss elementalLONDON 2026!

Join thousands of built environment professionals at Excel London, 25–26 November, for two days of innovation, expert insights and networking.

Discover the latest solutions in building efficiency, sustainability and decarbonisation, alongside London Build and CIBSE Build2Perform.

Find out more and secure your free ticket